Technical assistance
We want to clear the main technical questions that may arise about the operation of our products and the steps necessary for their assembly.
Table legs
The mechanism raises the table 13'5cm.
The tabletop must be larger than the structure, therefore it will depend on the chosen width. For the minimum length of 112 cm, the tabletop should measure 120 cm, and for the 152 cm one, it should be at least 160 cm. The minimum width is 60 cm.
No, the tabletop is not included, so you can combine it with the rest of the furniture. The components of the table are: 1 electric desktop structure with motor, 1 adapter, 1 up and down switch, instructions for use and mounting screws.
Feet
The maximum diameter that a table top or surface of a table can have with a Stay 5 or Stay 6 leg in order to avoid it toppling over when we support ourselves on one end is:\- 1,000 mm for the Stay 5 legs. \- 1,200 mm for the Stay 6 legs.
The maximum recommended tabletop that the board or table top with Duplo feet should have is 1.500 x 900 mm.
The maximum recommended tabletop that the board or table top with Hera feet should have is 900 x 900 mm.
The following diagram shows the detail of the machining that you need to carry out on the table top of a table in order to fasten the plate of the 60 - 80 feet.
Yes, it is possible to cut the 80 feet. To do so, you need to cut the foot at the leveller part, once this part has been disassembled, and make the cut with a cutting disk/saw that is suitable.
In order to know if a nut is compatible with a leveller, we have to look at the internal thread of the nut and at the thread of the leveller, which must coincide.For example, if we choose a 4 metric screw thread (M4), the nut also has to have an internal metric thread of 4 (M4).
Given that the unit load of each wheel is 70 kg, the complete Slip Ø100 4-wheel kit will withstand a weight of 280 kg.
